悬挂链生物接触氧化工艺处理河道污水

采用悬挂链曝气式接触氧化工艺在3个时段内处理城市河道污水,通过采用磷脂法、TTC-脱氢酶活性法和MPN法研究载体表面生物膜特性,来验证装置的水质净化效果。结果表明,进水水质变化幅度较大的时段1内,水质对缺氧区和好氧区内生物膜量及活性有很大冲击,对污染物的去除效果影响不大,COD、NH+4-N、TN和TP的平均去除率分别达到75.9%、80.8%、64.6%和78.3%;进水水质稳定的时段2内,缺氧区和好氧区内生物膜量和活性要高于其他时段,COD、NH+4-N、TN和TP的平均去除率分别达到77.0%、80.6%、69.4%和55.3%;低温运行的时段3内,缺氧区和好氧区内生物膜量和活性都低于其他时段,水质净化效果明显下降,COD、NH+4-N、TN和TP的平均去除率分别为71.1%、68.5%、48.9%和46.6%。     

大气颗粒物手工比对监测体系滤膜称量质控技术探讨

健全大气颗粒物手工比对监测体系是"十三五"环境空气自动监测质量管理的一项重点任务,其中颗粒物滤膜的称量直接影响手工监测数据质量。研究调研了国内各级环保部门所属环境监测机构颗粒物滤膜称量工作情况,结合国内外方法标准、技术规范等,重点探讨了称量实验室环境、称量设备、称量影响因素等滤膜称量质控要点,并针对环境管理与监测需求对大气颗粒物手工比对监测滤膜称量质控提出建议。     

利用SPAMS初探盘锦市冬季PM2.5污染特征及来源

利用SPAMS 0515于2015年1月在盘锦市兴隆台空气质量自动监测点位采集PM_(2.5)样品,并分析其污染特征和来源。研究结果表明,盘锦市冬季PM_(2.5)的颗粒类型主要以OC颗粒、富钾颗粒、EC颗粒组成。其中,OC颗粒占比最高,为52.5%;PM_(2.5)污染的主要贡献源为燃煤、生物质燃烧、机动车尾气排放,占比分别为33.2%、25.7%、17.5%,特别是在PM_(2.5)质量浓度较高时段,燃煤和机动车尾气排放对污染的贡献较大。     

Trait space of rare plants in a fire‐dependent ecosystem

The causes of species rarity are of critical concern because of the high extinction risk associated with rarity. Studies examining individual rare species have limited generality, whereas trait‐based approaches offer a means to identify functional causes of rarity that can be applied to communities with disparate species pools. Differences in functional traits between rare and common species may be indicative of the functional causes of species rarity and may therefore be useful in crafting species conservation strategies. However, there is a conspicuous lack of studies comparing the functional traits of rare species and co‐occurring common species. We measured 18 important functional traits for 19 rare and 134 common understory plant species from North Carolina's Sandhills region and compared their trait distributions to determine whether there are significant functional differences that may explain species rarity. Flowering, fire, and tissue‐chemistry traits differed significantly between rare and common, co‐occurring species. Differences in specific traits suggest that fire suppression has driven rarity in this system and that changes to the timing and severity of prescribed fire may improve conservation success. Our method provides a useful tool to prioritize conservation efforts in other systems based on the likelihood that rare species are functionally capable of persisting.     

柴油机微粒中可溶性有机成分的真空干燥条件

柴油机碳烟颗粒(PM)中可溶性有机组分(SOF)含量是其重要的特性参数,而真空干燥法可方便、高效、可靠地分析颗粒SOF含量,对其干燥条件的探索具有重要的研究意义和应用价值。首先采用模拟的柴油机颗粒,分析不同的干燥条件对模拟SOF(柴油、润滑油)挥发率的影响规律,得出模拟的SOF分析的最佳干燥条件;在此基础上,探索了真实柴油机颗粒SOF分析的最佳干燥条件为:干燥温度220℃、干燥时间3 h、真空度98 kPa,得知SOF组分干燥的难易程度介于柴油和润滑油之间;同时,根据此干燥条件,分析了排气管末端采集的真实碳烟颗粒的SOF含量特性。     

Fire as a Soil-Forming Factor

In the span of a human generation, fire can, in theory, impact all the land covered by vegetation. Its occurrence has many important direct and indirect effects on soil, some of which are long-lasting or even permanent. As a consequence, fire must be considered a soil-forming factor, on par with the others traditionally recognized, namely: parent material, topography, time, climate, living beings not endowed with the power of reason, and humans.     

Filtering with a drill pump: an efficient method to collect suspended sediment

Water quality monitoring programs across multiple disciplines use total suspended solids (TSS), and volatile suspended solids (VSS), to assess potential impairments of surface water and groundwater. While previous methods for instream filtering have been developed, the need for rapid, cost‐effective, high volume sampling has increased with the need to verify and supplement data produced by sondes and instantaneous data loggers. We present an efficient method to filter water instream with a portable drill pump that results in reduced sample processing time, and potentially reduced error associated with sample transportation, preservation, contamination, and homogenization. This technical note outlines the advantages of filtering instream vs. in the laboratory. It also compares TSS and VSS concentrations filtered with a drill pump vs. standard filtration methods with a vacuum pump as outlined by USEPA methods 160.2 and 160.4. Samples were collected at 4 sites and filtered in the field, or transported to the laboratory and filtered within 12 or 24 h of collection. Overall TSS and VSS samples filtered instream with a drill pump vs. in the laboratory produced similar concentrations with a similar range in variability for each method. Sample filtering with a drill pump decreased processing time by five minutes per sample.     

燃煤电厂在线监测系统颗粒物浓度排放系数影响因素的探讨

选取上海市7家未安装气-气换热器的国控燃煤电厂作为研究对象，从煤质、除尘器、脱硫协同脱除作用以及锅炉工况负荷等方面探讨对颗粒物浓度排放系数 K值产生的影响，得出上述因素通过改变脱硫进口颗粒物浓度值影响 K值，当脱硫进口颗粒物浓度较低、波动范围较小时，其 K值也维持相对稳定的状态；当脱硫进口颗粒物浓度较高、波动范围较大时，其 K值也会发生较大的变化等结论。     

污水处理移动床生物膜反应器悬浮载体研究进展

介绍了移动床生物膜反应器(MBBR)中悬浮载体的种类和特性,讨论了对其性能的影响因素,总结了当前悬浮载体改性技术及性能评价的方法,并对后续研究提出了建议。     

Environmental forensic investigation of the air pollution from a cement manufacturing unit

Abstract

Cement manufacturing is a process that results in the emission of significant quantities of suspended particulate matter (SPM) to the ambient air. An environmental forensic investigation was carried out in the surroundings of a major cement manufacturing unit at a place called Coimbatore in the southern Indian state of Tamil Nadu. The investigation was carried out to identify the contribution of the cement manufacturing unit to the SPM concentration of the surrounding air environment. The sampling points’ selection and sample collection were done following the principles outlined in the INTERPOL Manual for Pollution Crime Forensic Investigation. On-site monitoring of the air samples was carried out using Mini Laser Aerosol Spectrometer (GRIMM, Mini-LAS Model 11R). The instrument was capable of measuring particles ranging from 0.25 to 32 µm and classifying them into 31 size channels. The test results at majority of the monitoring locations were well above the limits specified in the National Ambient Air Quality Standards of India. Microscopic studies of the dust samples were carried out for surface texture and particle shape. The spatial distribution of particles was analysed using geographic information system (GIS) for the visual identification of the extent of the pollution by keeping the cement factory as the focal point. The results from the GIS and microscopic analysis established the role of the cement factory in the particulate matter pollution of its surroundings, specifically in the areas North-West of the factory. The successfully adopted procedure can serve as a guideline for the environmental forensic investigation of similar pollution incidences.